Hacking Question Black screen after booting hectate help please

[Haaris]

So switch serial is the possibly patched one, but i did test fusee on it and it said it was successful although never showed anything on screen.

So i went ahead to launch cfw it says smashing the stacks etc but it just still has black screen, i have updated fw for exfat cat already, and i have also reformated the sd card and still the same thing.
Anyone help please?
Thanks

 

[BryBread]

Format your SD card for FAT32; that has better compatibility and less chance of corruption. Try using AtlasNX, as that has everything preconfigured. Then report back if you still have a black screen. Chances are you're just using an outdated version of atmosphere/sept for the system version your switch is on.

https://switch.homebrew.guide

 

[Haaris]

Format your SD card for FAT32; that has better compatibility and less chance of corruption. Try using AtlasNX, as that has everything preconfigured. Then report back if you still have a black screen. Chances are you're just using an outdated version of atmosphere/sept for the system version your switch is on.

https://switch.homebrew.guide

I already followed everything on that website using fusee-gelee method

 

[Resaec]

That sounds like a patched unit to me.
You should use TegraRCMGUI. It will help you setup drivers, tell you when the Switch is detected in RCM and push the payload reliably.
You should push Hekate to see if your Switch is patched or not. If Hekate does not show up your Switch is patched.