RGH3 NAND Flash Mistake and Console Not Found in J-Runner.

[KIlly728]

I need some help.

Did the RGH3 Hard Mod on a 4gb Corona Slim. Everything went well. This is my 4th console i've done this mod to,, but my first time with a 4gb Corona.

As I go to begin installing software, Dash Launch, Aroura, etc, I noticed in Dash Launch that I flashed the console as Trinity, and not Corona. Not sure how that happened, but here we are.

I disassemble the console and hook my Pico back up. I got into J-Runner, and it cannot detect my console. If I click the "?" next to the Flash Type, however, it does see it is a 4GB Corona eMMc, but when I go to read the Nand, I get "Console Not Found".

I have:

• Checked the wiring of my Pico to ensure it is both correct and solid. Followed the image guide on Console Mods
• Tried a couple of different USB cables
• Redownloaded and reflashed Picopflasher several times.
• Restarted J-Runner, as Admin, and restarted my PC several times.

The only thing I cannot check is if the Pico is the problem. I only have one freely available, so that is the only unknown factor.

Any help would be appreciated. I don't know if I need to do anything special in order for it to read since it is no longer a retail console.

In case the solder job is called into question, here are the joints. They aren't pretty, but they're also not permanent.

 

[Deleted member 681324]

Just asking the obvious... you have the psu plugged into the console during r/w?

 

[KIlly728]

Just asking the obvious... you have the psu plugged into the console during r/w?

Yes. Also tried a different PSU with no change.

As an update, I cross-posted this on Reddit, and why Dash Launch is showing a Trinity Flash on my Corona motherboard isn't because I made a mistake; rather, it was intended. I think it is a bit silly, and only slightly confusing, but it is a relief.

As for why I cannot reconnect to this console to reflash it, I still do not understand.

For Posterity:

I didn't try this, but it is a possible solution.