Hardware Pulled my switch's battery connector off board

[Kanond1]

I've replaced joycon shells plenty of times so I assumed this would be fun. So what are my options? I have a soldiering iron. Is there any way to fix this?

I would post a pic but I'm too new here.

 

[Patapon3321]

With a soldering iron will be this hard and u need concentrations and tiny soldering tip. With a hotairgun will be this more easier

 

[Everlasting1337]

Show me the damage, that's not too bad. Have you ripped the pads off? Depending on that this can be an easy or moderate repair.

 

[nero99]

With a soldering iron will be this hard and u need concentrations and tiny soldering tip. With a hotairgun will be this more easier

That will melt the plastic connector.

 

[Everlasting1337]

If you did and it's messed up, then solder the wires there black to black test point. Solder the grey to the test point and the red, scratch the surface and solder it there. If the pads are still there then solder the wires to the pads directly. Best of luck, don't rush it

 

[byobr]

I also have this problem, but also dont have this spot for the white wire of battery, if i power on only with red and black, it froze on game starts, any other location that i can solder this white whire?:

 

[jkyoho]

I also have this problem, but also dont have this spot for the white wire of battery, if i power on only with red and black, it froze on game starts, any other location that i can solder this white whire?:

 

[lolilea]

View attachment 297630

Bonjour pouvez-vous me dire a quoi correspondent les numéro ? quel fils ? merci

 

[jkyoho]

Bonjour pouvez-vous me dire a quoi correspondent les numéro ? quel fils ? merci

those numbers are just random test point numbers, no specific meaning. You should check the test point traces from the PCB boardview post thanks to @slimeinacloak