So I'm at this step on this page:
https://github.com/Plailect/Guide/wiki/Part-3-(A9LH)
So I got to this point, did every step perfectly, checked every step multiple times while doing it. Now when I start my 3DS, it's just a black screen. :/ I can load back into Luma by holding Select before turning on my 3DS. Turning on the 3DS without the SD card makes it just turn off again immediately. Turning it on with the SD card, it's just black, nothing happens. I'm not holding any buttons when booting, as it doesn't say to hold anything.
Did it brick? I did everything perfectly T_T
Any ideas?
https://github.com/Plailect/Guide/wiki/Part-3-(A9LH)
- Use the (A) button and the D-Pad to turn on the following:
- "Autoboot SysNAND"
- "Use SysNAND FIRM if booting with R (A9LH)"
- "Show NAND or user string in System Settings"
- "Show GBA boot screen in patched AGB_FIRM"
- This may cause crashes for some injected GBA Virtual Consoles
- If some games do not work properly, disable this option and try again
- Press Start to save and reboot
- If it freezes, hold the power button until it shuts down, then continue with the instructions
So I got to this point, did every step perfectly, checked every step multiple times while doing it. Now when I start my 3DS, it's just a black screen. :/ I can load back into Luma by holding Select before turning on my 3DS. Turning on the 3DS without the SD card makes it just turn off again immediately. Turning it on with the SD card, it's just black, nothing happens. I'm not holding any buttons when booting, as it doesn't say to hold anything.
Did it brick? I did everything perfectly T_T
Any ideas?