The chip is labeled as Xen8gc, wired it to the board and it seems to be functioning. Red light blinks once on bootup, then blinks along with the laser. While holding Start and running a oem disc, I get the version display/pal.
I've tried multiple DVD-Rs(including Verbatim), two different dvd drives (An ASUS and a Sony), using imgburn software at 4x speed for all attempts(4x is lowest it will allow), and yet to get a game to launch. I've adjusted the pot many times, keeping it within the 180+ range.
Seems that no matter what I do, I get the "An error has occurred. Turn the power OFF and check the NINTENDO GAMECUBE instructions booklet for further instructions. Anyone know what could be causing this?
Edit: Lowering the pot down to 75 ohm seems to have fixed my issue.
I've tried multiple DVD-Rs(including Verbatim), two different dvd drives (An ASUS and a Sony), using imgburn software at 4x speed for all attempts(4x is lowest it will allow), and yet to get a game to launch. I've adjusted the pot many times, keeping it within the 180+ range.
Seems that no matter what I do, I get the "An error has occurred. Turn the power OFF and check the NINTENDO GAMECUBE instructions booklet for further instructions. Anyone know what could be causing this?
Edit: Lowering the pot down to 75 ohm seems to have fixed my issue.
Last edited by Toomuchsugar,
