Trying to clone OLED's eMMC with this module.

[FreeLander]

Hello,

I reballed my eMMC, and installed Ubuntu on VM, it is shown as "norelsys 1081 usb device" but it does not get connected to Ubuntu, I get an error.

https://www.aliexpress.com/item/328....order_list.order_list_main.11.b27e1802aFiXB4

The module just stays on a red light.

Is this related to my rebaling, or the device, or am I missing something?

Thanks.

 

[Hassal]

Already replied to you but after checking the data sheet of that controller it seems to only support up to eMMC4.5 not sure if higher specification is possible through this.
https://en.sekorm.com/doc/2156606.html

In any case, this reader will do you no good because it can only read the rawnand partition.
You're going to need something like these to gain full access to all your drive partitions
https://www.aliexpress.com/item/1005003618552075.html
https://www.tindie.com/products/ignas/emmc-reader-for-hac-emmc/

 

[FreeLander]

Already replied to you but after checking the data sheet of that controller it seems to only support up to eMMC4.5 not sure if higher specification is possible through this.
https://en.sekorm.com/doc/2156606.html

In any case, this reader will do you no good because it can only read the rawnand partition.
You're going to need something like these to gain full access to all your drive partitions
https://www.aliexpress.com/item/1005003618552075.html
https://www.tindie.com/products/ignas/emmc-reader-for-hac-emmc/

Thankk you again. I appreciate the time you spent reading the datasheet. <3