1. lpoolm

    OP lpoolm GBAtemp Regular
    Member

    Joined:
    Jun 20, 2017
    Messages:
    278
    Country:
    United Kingdom
    Hi so trying to take my dead switch back alive, I can load it into hekate but have noticed the touch screen does not work all over the screen?
    Basically it works around the edges but not in the middle?
    Could this be down to the connection from the screen to the board?
    Does anyone know which ribbon cable it is that controls touch so I can see if there are any bent pins?
    Thanks
     
  2. bombob

    bombob Advanced Member
    Newcomer

    Joined:
    May 4, 2020
    Messages:
    87
    Country:
    United States
    Its connected to the cartridge reader.

    Sent from my SM-N960U using Tapatalk
     
  3. lpoolm

    OP lpoolm GBAtemp Regular
    Member

    Joined:
    Jun 20, 2017
    Messages:
    278
    Country:
    United Kingdom
    Thanks, not where I was expecting!
     
    bombob likes this.
  4. bombob

    bombob Advanced Member
    Newcomer

    Joined:
    May 4, 2020
    Messages:
    87
    Country:
    United States
    The ribbon for the picture goes straight to the board and the backlight ribbon is located on the bottom next to the joycon ribbon.Just in case

    Sent from my SM-N960U using Tapatalk
     
    lpoolm likes this.
  5. andres1234

    andres1234 Advanced Member
    Newcomer

    Joined:
    Nov 21, 2019
    Messages:
    78
    Country:
    Chile
    i have this problem, i change card reader and fix the touch
     
    lpoolm likes this.
Draft saved Draft deleted
Loading...

Hide similar threads Similar threads with keywords - screen, Touch, works