Hardware Switch stuck on boot

[Pavekxx]

Hello everyone. So I did a maintence job for my switch some time ago. Cleaned it and applied new thermopaste. Now its works fine on nyx but stuck on nintendo switch logo while bootting.
Tried to format the SD card but with no sucsess.
P.S. I`ve noticed that while booting the fan is not working, may this be the problem?

 

[Pavekxx]

Hello, getting an update on the situation. After opening the switch again I noticed that a component is missing, most likly came of when I was taking off the CPU shield. After looking under the microscop I was able to verify that the component indeed missing. I can solder it back but I need help indentifing it. It`s a differantial signal so the component near it should be the same but it so small (0201) thats it hard to tell. It can be a capacitor but more likely a resistor or a firite bead. If someone know the nominal or the component type it would be a great help!

 

[jkyoho]

they are both 100nf(0.1uf) capacitor size 0201

 

[Pavekxx]

Thank you, ill try them