Hacking Homebrew Switch mod power start cfw

[PatrizioP]

Can anyone help me? After updating atmosphere on switch it takes a long time to start. before it started immediately

 

[hartleyshc]

I've noticed this happening in the past with previous updates. Not on this current update, but in Horizon updates in the past. I don't think its really an atmosphere problem, more of a OFW problem.

Either way, just use hwfly-toolbox and reset your training data and have your mod chip train again.

 

[PatrizioP]

I've noticed this happening in the past with previous updates. Not on this current update, but in Horizon updates in the past. I don't think its really an atmosphere problem, more of a OFW problem.

Either way, just use hwfly-toolbox and reset your training data and have your mod chip train again.

I did the procedures but it gives me this error . it doesn't turn green when I do power vol +

 

[hartleyshc]

Its in the instructions for hw-fly toolbox, but you must keep holding down the + button while you boot. The modchip will keep flashing green after you boot into hekate. Then you can go into hwfly-toolbox and try to reset the training.

 

[PatrizioP]

Its in the instructions for hw-fly toolbox, but you must keep holding down the + button while you boot. The modchip will keep flashing green after you boot into hekate. Then you can go into hwfly-toolbox and try to reset the training.

it only flashes purple I don't know what I'm doing wrong

Post automatically merged: Oct 26, 2023

I tried the chip continues to flash purple for 2 minutes and then turns red

Post automatically merged: Oct 26, 2023

sends me to this screen. If I go into Hekate and update the firmware and SD loader and reboot, nothing changes