I followed the guide for a V2 switch. But the switch does not start. No light goes on on the RP2040 Zero either.
I tried on my second switch V2 and same problem. The flashing of the uf2 file was successful. I used 0.1mm wire and kept it as short as possible.
On the second switch I accidently killed the GND cap (I don't know what value that cap is so if someone could tell me so I can replace it that would be great).
FYI: if I desolder the wires from the RP2040 the switch starts normally again..
I tried on my second switch V2 and same problem. The flashing of the uf2 file was successful. I used 0.1mm wire and kept it as short as possible.
On the second switch I accidently killed the GND cap (I don't know what value that cap is so if someone could tell me so I can replace it that would be great).
Post automatically merged:
FYI: if I desolder the wires from the RP2040 the switch starts normally again..
Last edited by impy101,
