Hacking RCM and Switch wont boot

[Jetk1986]

Hi i have problem here, I plugged in my RCM and it showed Boot.DAT? I have unplugged. and tried to turn on, Now my switch wont turn on.
This screwed my switch ?!?!? Please help! what do i need to do...

 

[thesjaakspoiler]

You might have run out of power.
Just let your Switch charge for an hour and try again.

Other possibilities are that your RCM injector ran out of power.
Does it show any lights?

The first message indicated that the boot.dat couldn't be found.
It's either missing, the wrong version, your sd card got messed up (exfat?) or your sd card reader broke.

 

[Jetk1986]

You might have run out of power.
Just let your Switch charge for an hour and try again.

Other possibilities are that your RCM injector ran out of power.
Does it show any lights?

The first message indicated that the boot.dat couldn't be found.
It's either missing, the wrong version, your sd card got messed up (exfat?) or your sd card reader broke.

hmmm strange...
my battery was full at charge.
i am not sure the RCM loader messed it up again.
I was using it normally using the normal boot.
then i wanted to try the RCM, it went to boot.dat.
then totally shut off. I hope i didnt break the motherboard chip or something?

 

[Draxzelex]

hmmm strange...
my battery was full at charge.
i am not sure the RCM loader messed it up again.
I was using it normally using the normal boot.
then i wanted to try the RCM, it went to boot.dat.
then totally shut off. I hope i didnt break the motherboard chip or something?

Did you check to see if your SD card is fake or not?