PS5 1 Second BloD UART C002C0002

[davidroman2494]

Hello!

I'm tying to fix a PS5 that has a 1 second BloD. UART code reads a general power failure code and then a C00C0002

Severe VRM Controller Failure, Check Mosfet (6414A) Located Side-A, Below Sony Interactive Entertainment Inc. Check Infineon XDPE14286A 16 Phase PWM Controller - Located Side-A, Right of fuse 7001 - Single Beep, 1 second blue light, off.

I've checked around every 6414A mosfets and all of them looks fine. Infineon IC has no shorts around it and diode readings looks fine but I don´t really have a known good board to compare. I saw the VCore line to not be there when turning on the console and this line to have a really low resistance to ground, around .3 Ohms to ground and 0 Voltage drop. I've tried injecting .7V into this line it will take like 1.2A and the APU will get hot slightly and slowly but nothing else.

Is this board toast?

 

[cene]

I have the same problem afrer power cut

Post automatically merged: Nov 28, 2024

there is no shorts, did you fix your console?

 

[davidroman2494]

I have the same problem afrer power cut

Post automatically merged: Nov 28, 2024

there is no shorts, did you fix your console?

Nope, I've asked over some discord channels and it might be either a dead APU or a cracked solder ball. Didn´t try to reflow or reball bc I don´t have the tools sadly