hi please i need to correct picofly schematic rp2040 zero for v2 mariko with flex cable v2 do avoid any damage for the switch
thank u
thank u
hi please i need to correct picofly schematic rp2040 zero for v2 mariko with flex cable v2 do avoid any damage for the switch
thank u
1. Bridge 2 middle pins and you will have 2 pins left on each side and run wire from the 2 bridged pins to the cpu point on picothank u for your answer
i have same question please :
1 : ON THE FLEX cable there are 6 pin do i need solder pin 3 and 4 together to the cpu rp2040 ?
2 : do i need solder the v2 flex cable like normal solder same as hwfly on APU ?
3 : do i need solder the DAT 0 on mother bord on the the two pin together ?
thank u
thank u1. Bridge 2 middle pins and you will have 2 pins left on each side and run wire from the 2 bridged pins to the cpu point on pico
2. Yes solder like normal
3. Both pins connect so can use 1 or both same time on cmd, clk, dat
400-600 diode mode red probe on ground.Is there a document or a link to measure my installation and check before powering up. as a precaution, that is to say what value I must have exactly to avoid the short circuit and the death of NAND.
and big thank again for your help
PICOFLY YES BUT I HAVE MADE other installation before with hwfly.Is this your first mod?