Picofly OLED Error *== or *=*

[Megradome]

Hey All,

I am having a issue with this install, I have done plenty OLED's but this one is causing me a lot of issues. I can't seem to get the modchip to glitch the console it just boots straight into OFW and doesn't glitch it. The error looks like *== or *=* but I provided a video anyways. Any idea which solder could be causing this?

I am not sure which point is causing this, any help is appreciated. Sorry for poor picture quality.

 

[Deleted member 693035]

*=* No eMMC block 0 read (eMMC init failure?)
*== No eMMC CMD1 request (poor wiring, or dead CPU)

 

[Megradome]

*=* No eMMC block 0 read (eMMC init failure?)
*== No eMMC CMD1 request (poor wiring, or dead CPU)

I saw these and I don't really understand them or how to fix them.

 

[CMDreamer]

If you are unable to find the culprit, I'd say start over.

Its easier to do all the soldering again, than try tracking into something that could be anything.

 

[MoeXzl]

The pictures may be deceiving. Do you have cold solder joints or are you working at too low a temperature?

 

[Megradome]

The pictures may be deceiving. Do you have cold solder joints or are you working at too low a temperature?

I use 350C, is that a good temp?

 

[Aymenmoham]

Same problem
But mine not booting ofw

Post automatically merged: Jul 28, 2024

I have done plenty OLED's more than 40
But this one first time *=*

 

[snoozed]

Any solutions? I got the same problem.

 

[superfiege]

I have had this problem several times on perfectly soldered oleds. With flex cables and with wires. Reworked all solder-points. Nothing fixed the problem.

It only happens about 1 out of 10 glitching tries.

Searching for solutions I figured out the only way (for me) is to replace the picofly with an instinct-chip. I dont like this solution, but it works for me.