Part 3 Rednand

Discussion in '3DS - Homebrew Development and Emulators' started by wildwarria, May 13, 2016.

  1. wildwarria
    OP

    wildwarria Member

    Newcomer
    15
    0
    May 12, 2013
    United States
    Hello everyone on part 3 (Rednand Setup) with Plailect/Guide however pressing A does not do anything
    as the % stays on 0. It does jump to 20% right away when you press down on the directional cross
    and remains there as now progress is being made. Any help is greatly appreciated.

    Thanks in advance.
    13169818_10209210532800426_892779589_o.jpg
     
  2. FeierabendTV

    FeierabendTV Member

    Newcomer
    14
    3
    Mar 4, 2015
    Gambia, The
    You need to press 'down up left right A' in order to start it
     
    Last edited by FeierabendTV, May 13, 2016
    wildwarria likes this.
  3. DinckelMan

    DinckelMan Your Favorite Water Mage!

    Member
    255
    155
    Nov 4, 2013
    United States
    Press the combination of keys that is written on your screen and after that you will be able to change the filename. It was a bit confusing for me too
     
    wildwarria likes this.
  4. wildwarria
    OP

    wildwarria Member

    Newcomer
    15
    0
    May 12, 2013
    United States
    Thanks everyone!

    Currently on steps;

    14)Reinsert your SD card into your 3DS, then press Start to reboot.
    15)Get into the Homebrew Launcher through the entrypoint of your choice

    However pressing down on reboot or powering on does not load homebrew.
    System Settings says Ver. 9.2.0-20U

    Re-installed homebrew on step 21 (Open TinyFormat) and went through the folders
    3ds/TinyFormat/TinyFormat and then choosed Y to start

    Finished step 23
    initial setup without linking your Nintendo Network ID, you want it to remain linked only to RedNAND to prevent issues (on Ver. 9.2.0-20U)

    Tries to boot back into homebrew and it is gone again.
    1) Should homebrew tried to be installed again?
    2) Why not seeing Emu on version number?

    Any help greatly appreciated.
     
    Last edited by wildwarria, May 15, 2016
  5. MZ-4

    MZ-4 Member

    Newcomer
    32
    8
    Nov 9, 2015
    Gambia, The
    Can't remember problems at that stage.
    Perhaps your design of home menu changed and so menuhax won't work on the down-key.

    Since I needed another way to start Homebrew anyway, I got a OoT cart prepared for 9.2.
    Can you start Homebrew when you use an other way? Ninja, OoT,...?
    If so, just reinstall menuhax and configure the Down key again if needed.
    ...menuhax method is just for convenience, I think.
    You could also use any other method to start your Homebrew instead.