Hello,
i got a switch for cheap on ebay.
I got it when it was stuck in autorcm, but shortly after that i figured out that it wasn´t really stuck in autorcm.
When the emmc got detected it booted to the Nintendo Logo but black screen after that.
I desoldered the emmc and connected it with my PC via. SD to check it with HackDiskMount. I could read out all the partitions except "System". It stops at reading 1% of it and give me an error message that there was an error while reading.
Also with hekate it fails at verification when it has done reading the first 6% out of the emmc (And its also very slow, took about 16min to read out. Is there a way to recover this switch?
Best regards
Cygnos
Also i have a replacement emmc from another switch which read and write perfectly
i got a switch for cheap on ebay.
I got it when it was stuck in autorcm, but shortly after that i figured out that it wasn´t really stuck in autorcm.
When the emmc got detected it booted to the Nintendo Logo but black screen after that.
I desoldered the emmc and connected it with my PC via. SD to check it with HackDiskMount. I could read out all the partitions except "System". It stops at reading 1% of it and give me an error message that there was an error while reading.
Also with hekate it fails at verification when it has done reading the first 6% out of the emmc (And its also very slow, took about 16min to read out. Is there a way to recover this switch?
Best regards
Cygnos
Also i have a replacement emmc from another switch which read and write perfectly
Last edited by CygnosOne,
