Hello. I just installed the Nintendo 64 Advanced and now I need to make a component cable for it. I'm unable to post a link to the guide I've been following due to my post count being too low, but I've been using the one on the 8bitmods website. My plan is to take the Multi-Av plug from a Nintendo branded cable and splice it onto a Wii component cable, but am a little confused by the chart provided and I don't want to waste 2 cables. I'm assuming cutting the plug off the Wii component will show 5 shielded cables and overall ground. I would connect the cables like this:
Pr to Multi-AV Pin 1, Shield to Pin 5 or 6?
Y to Multi-AV Pin 2, Shield to Pin 5 or 6
Pb to Multi-AV Pin 4, Shield to Pin 5 or 6
Audio L to Multi-AV Pin 11, Shield to Pin 5 or 6
Audio R to Multi-AV Pin 12, Shield to Pin 5 or 6
Overall Ground to Pin 5 or 6?
I shouldn't need Sync or +5V. Also would I still put the 220uF caps on PrPbY? Will any Multi-AV Nintendo branded cable have all the pins inside? Hope I'm not way off. Thanks for the help.
Pr to Multi-AV Pin 1, Shield to Pin 5 or 6?
Y to Multi-AV Pin 2, Shield to Pin 5 or 6
Pb to Multi-AV Pin 4, Shield to Pin 5 or 6
Audio L to Multi-AV Pin 11, Shield to Pin 5 or 6
Audio R to Multi-AV Pin 12, Shield to Pin 5 or 6
Overall Ground to Pin 5 or 6?
I shouldn't need Sync or +5V. Also would I still put the 220uF caps on PrPbY? Will any Multi-AV Nintendo branded cable have all the pins inside? Hope I'm not way off. Thanks for the help.