Kamikazi Pointless OLED Switch

[LucasRomeiro]

I found 2 Switch OLED consoles without a kamikazi dot! Very strange! I believe the manufacturer moved this dot to make the unlocking process more difficult! I have a lot of experience and have done this process a lot and this is the first time I have encountered this situation, they are 2 new consoles, recently purchased! Has anyone seen this? I opened the place even more to check if I found something, but as you can see in the images, there is no dot!!

 

[LuigiGad]

but don't you have to dig up the data that remained buried?
I made a new OLED from the shop XTJ8xxxx and I had no problems

 

[LucasRomeiro]

but don't you have to dig up the data that remained buried?

Yes, but clearly when looking through the fiberglass of the plate, the round point of the kamikazi does not exist… there are other trails, in a different geometry!

 

[LuigiGad]

Yes, but clearly when looking through the fiberglass of the plate, the round point of the kamikazi does not exist… there are other trails, in a different geometry!

Can you report the initial part of the serial so we understand?

 

[LucasRomeiro]

Can you report the initial part of the serial so we understand?

Sure. Here:XTJ505111840**

 

[LuigiGad]

Sure. Here:XTJ505111840**

I worked on a much newer one

 

[LucasRomeiro]

I worked on a much newer one

Strange… I will remove more fiber off PCB to test it… to see if have or no an different net.

 

[randy_w]

Does the console still boot up?

 

[deeps]

looks like you didn't grind deep enough. you haven't fully passed through the mask layer below the second ground layer

 

[LucasRomeiro]

I identified the problem! The color of the fiberglass used in this board is very different from normal. It is difficult to show this in the images. But it is dark and makes it very difficult to see the kamikaze point, giving the impression that it does not exist and that there are other trails underneath. But I opened it a little more, slowly, and managed to access the correct point. All the confusion was because of the darker and strange color of the fiberglass, causing confusion. I appreciate everyone's help!