Hacking JIg Done but cant boot RCM

[Franspi]

I did the clip jig, the console doesnt start like it normally would, but instead it stays turned off until i remove the clip. what shall i do?

 

[Moe87]

I did the clip jig, the console doesnt start like it normally would, but instead it stays turned off until i remove the clip. what shall i do?

Did you try to hold on volume + and power on at same time?

 

[Franspi]

Did you try to hold on volume + and power on at same time?

Yep and nothing happens

 

[jakkal]

Did you try sending the payload?
When it's in RCM mode the screen is completely off also

 

[Moe87]

Yep and nothing happens

It appears that your paperclip didn't contact the pins, so need to bend the paperclip slightly more. You have to be more carefully to not damage the pin.

First, if your Switch is black screen so you may be in RCM so need to send a payload via USB until you see commands, so there is no way to tell if you are in RCM until you send a payload, however if Nintendo logo boot up so you aren't in RCM.

 

[Franspi]

Did you try sending the payload?
When it's in RCM mode the screen is completely off also

To send the payload i used the android app and nothing happens

 

[jakkal]

To send the payload i used the android app and nothing happens

Maybe your phone doesn't support otg
Or you didn't give your phone permission

Try using your PC

 

[magico29]

first thing you need to do is confirm the console(switch)is on RCM mode and then you proceed.

 

[wicksand420]

Also, make sure your phone is compatible with NXLoader, what phone do you have?