I was thinking of using my hot air gun (8858) to heat from beneath but I realized there were other components there, how should I go about heating it? What temp/airflow should I go with?
Hardware How do I replace the fpc connector for the left joycon ?
- Thread starter InternetRelative
- Start date
- Views 938
- Replies 2
I was thinking of using my hot air gun (8858) to heat from beneath but I realized there were other components there, how should I go about heating it? What temp/airflow should I go with?
You can shield the other components with a few layers of kapton tape.
But this guy has a good video about it :
But this guy has a good video about it :
- Joined
- Sep 2, 2020
- Messages
- 453
- Trophies
- 0
- Age
- 38
- Location
- TORONTO
- Website
- form.jotform.com
- XP
- 1,222
- Country
Remove the white piece button pad. heat it from bottom around 350~380C with less air flow.tint the connector pads with leaded solder will reduce the heating process
Similar threads
- Question
- No one is chatting at the moment.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
@
Jayro:
We need more progressive fireballs like AOC in politics, she handled that heckler like a champ. -
-
-
@
FAST6191:
if we can have economic literacy, decency and respect for rights then so much the better but that is asking too much. -
@
Xzi:
Even if AOC had gone straight from being a bartender to running for president, she would've been preferable to the last two guys we elected -
-
