Hardware Error code 2134-0501

[tracktor]

Hi guys,

I have a switch that was on fw 6.2.0 and I wanted to install a modchip on it (trinket m0 with Simple-UF2) on it. So first I booted in RCM, loaded hekate, did a full nand backup before doing anything else. So I actually have a safe backup from 6.2.

After that I installed the trinket, it did work fine. It is installed to directly boot hekate everytime.

I tested booting atmosphere and sxos and it worked fine.

At one point when starting a game I misclicked and the console updated to 7.0.1. At that point, I downgraded to 6.2.0 using ChoiDuJourNX. It worked, rebooted again in 6.2.0 with cfw was fine.

I then closed the cover to finish properly install the trinket, but a wire broke (I used 0.1mm wires) (the one that went to right joycon). I redid the connection, and now when I start the console, hekate boots the cfw (sxos or atmosphere), I get the nintendo logo, the switch logo, than it shows me an Error Code 2134-0501 and says that I need to shutdown the switch... Nothing else...

I already restored my original 6.2 nand backup, and also removed the modchip and boot normally. It does not change, all I get is this error code.

I'm actually out of idea on what to do now.

Anyone has any clue?

Thanks

 

[diego0098]

hi i can know if you can fix the problem have a switch with the same problem

 

[tracktor]

No, Switch is dead. It does not charge anymore. changed some power chips on it, but still the same.

 

[HollowGrams]

No, Switch is dead. It does not charge anymore. changed some power chips on it, but still the same.

Just fixed my switch with exact error code

Replaced M92736 then error changed to 2010-0001. Replaced M92736 again and its working.