Controller Wiring Questions

Discussion in 'Nintendo GameCube' started by gudenaurock, Jun 19, 2012.

Jun 19, 2012
  1. gudenaurock
    OP

    Member gudenaurock Never a unique idea

    Joined:
    Jul 7, 2010
    Messages:
    2,953
    Location:
    /dev/random
    Country:
    United States
    Do the analog stocks and shoulder buttons have a common ground? If so is it shared with the buttons?
     
  2. FAST6191

    Reporter FAST6191 Techromancer

    pip
    Joined:
    Nov 21, 2005
    Messages:
    21,705
    Country:
    United Kingdom
    Alas http://hitmen.c02.at/files/yagcd/yagcd/frames.html http://www.int03.co.uk/crema/hardware/gamecube/gc-control.htm and http://www.allpinouts.org/index.php/Nintendo_Gamecube_controller_connector_pinout did not tell me.

    I am not sure about this controller but it seems my green and white had a resistance in the meg Ohms (around 3 of them)

    c ground was green
    green was the order of the day for the triggers (I did test internally for these though)
    z button case ground was green
    the few buttons I tested went to green
    left stick and c appeared to share a common ground (it was awkward so I only managed to confirm low resistance between what looked to be the stick and the c grounds
    rumble seemed to go to white (I did not bother to look hard enough for a feedback diode) but having logic and power using different grounds works well.

    Black and green were common.
     
  3. gudenaurock
    OP

    Member gudenaurock Never a unique idea

    Joined:
    Jul 7, 2010
    Messages:
    2,953
    Location:
    /dev/random
    Country:
    United States
    Oh, looks like it is done well. :-)
     

Share This Page