Hey, all!
I know this is the bajillionth thread like this (because I've read through a lot of them trying to figure this out), but I got a bit careless at some point and screwed up my Switch.
I should note that I can still boot into RCM, so I don't think everything is lost, or anything. I'm just at my wits end.
I finally decided to bite the bullet yesterday and mod one of my Switches. My system's original firmware is 7.0.1, 9 fuses burned. I performed a backup of BOOT0 and BOOT1, plus my RAWNAND. I was originally using a 64GB SD card in FAT32 format.
I'd been using fusee-primary to boot into Atmosphere and began downloading useful homebrew apps. I then decided to load a backup NSP using Goldleaf via Goldtree, which was successful, but the required firmware for it was higher than what I had. I'd planned to use ChoiDuujour NX to upgrade to 8.0.1 and use AutoRCM, but then I also decided to swap all of my files to a 128GB SD card. Right after that, the system began failing to boot. I hadn't actually done anything past that.
I attempted to restore my NAND backup. No success.
I then decided to use ChoiDujour to downgrade the system to 6.0.1, then upgrade back to my original firmware and live with what I had for a while. After successfully downgrading, using Team Atlas NX's guide, the system still didn't boot into either OFW or CFW.
I figured at that point that I've missed something obvious, so I'm beseeching the experts.
I know this is the bajillionth thread like this (because I've read through a lot of them trying to figure this out), but I got a bit careless at some point and screwed up my Switch.
I should note that I can still boot into RCM, so I don't think everything is lost, or anything. I'm just at my wits end.
I finally decided to bite the bullet yesterday and mod one of my Switches. My system's original firmware is 7.0.1, 9 fuses burned. I performed a backup of BOOT0 and BOOT1, plus my RAWNAND. I was originally using a 64GB SD card in FAT32 format.
I'd been using fusee-primary to boot into Atmosphere and began downloading useful homebrew apps. I then decided to load a backup NSP using Goldleaf via Goldtree, which was successful, but the required firmware for it was higher than what I had. I'd planned to use ChoiDuujour NX to upgrade to 8.0.1 and use AutoRCM, but then I also decided to swap all of my files to a 128GB SD card. Right after that, the system began failing to boot. I hadn't actually done anything past that.
I attempted to restore my NAND backup. No success.
I then decided to use ChoiDujour to downgrade the system to 6.0.1, then upgrade back to my original firmware and live with what I had for a while. After successfully downgrading, using Team Atlas NX's guide, the system still didn't boot into either OFW or CFW.
I figured at that point that I've missed something obvious, so I'm beseeching the experts.