Laptop: Lenovo Y560p Windows 10 x64 Bits
Devices
H2testw: Finished without errors.
HP USB Disk Storage Format Tool: Don't read the device.
SD Card Formatter: Correctly formated, but in FAT.
Diskpart: Correctly formated in FAT32.
Otras anotaciones:
Before I used a 4GB SD Card and everything worked perfectly, at the moment of configuring the unlaunch I got the respective BOOT.NDS file. Of course, I was following the recommendation to fill part of the card with X files so that it would have 2GB available.
I could not continue using that card and I was left with the "2GB" and I thought that everything would be better because it is the one recommended, but nothing.
I wanted to be as specific as possible to avoid the "Try this...I already tried this" dialog. This way we can go straight to solutions that I haven't specified here.
I have visited posts where they raise similar problems but in the end they don't come up with anything specific.
Thank you very much in advance.
Devices
- Micro SD Adapter: Kingston technology .
- Micro SD: SanDisk 2 GB (1,83).
- With Allocation unit size from 32768
- ERROR
FSCTL_ALLOW_EXTENDED_DASD_IO OK
ClusterCount=60334
FAT32 must have at least 65536 clusters, try to specify a smaller cluster size or use the default
Somewhere I read that the cards had to be formatted in this way, and when I did it with a 4GB card it ran successfully. I don't know if that number changes for smaller capacity cards.
- ERROR
- With Allocation unit size from 4096
- PASSED
FSCTL_ALLOW_EXTENDED_DASD_IO OK
GuiFormat version 1.02 x86 Windows version 0602 64 bit
Size : 1GB 3862393 sectors
512 Bytes Per Sector, Cluster size 4096 bytes
Volume ID is f14:3737
32 Reserved Sectors, 3765 Sectors per FAT, 2 fats
481853 Total clusters
481852 Free Clusters
Formatting drive D:\:...
Clearing out 7570 sectors for Reserved sectors, fats and root cluster...
Wrote 3875840 bytes in 0.39 seconds, 9.48 Megabytes/sec
Initialising reserved sectors and FATs...
Done
If you find this code useful please consider donating at
http://www.ridgecrop.demon.co.uk/guiformat.htm
When I install TWiLightMenu formatted in this way two things happen:- UnLaunch opens normally but when I assign BOOT.NDS as NO BUTTON I can't locate the file.
- The UnLaunch gives me an MBR Empty error.
- PASSED
H2testw: Finished without errors.
HP USB Disk Storage Format Tool: Don't read the device.
SD Card Formatter: Correctly formated, but in FAT.
Diskpart: Correctly formated in FAT32.
Otras anotaciones:
- I noticed that the adapter does not have the Block Switch activated.
- All programs using have been run with Administrator permissions.
Before I used a 4GB SD Card and everything worked perfectly, at the moment of configuring the unlaunch I got the respective BOOT.NDS file. Of course, I was following the recommendation to fill part of the card with X files so that it would have 2GB available.
I could not continue using that card and I was left with the "2GB" and I thought that everything would be better because it is the one recommended, but nothing.
I wanted to be as specific as possible to avoid the "Try this...I already tried this" dialog. This way we can go straight to solutions that I haven't specified here.
I have visited posts where they raise similar problems but in the end they don't come up with anything specific.
Thank you very much in advance.
