Search results

  1. T

    HWFLY OLED Purple / Orange / Red

    Hey guys, Starting info: OLED console running 14.1.1 V4.0 HWFLY install with upgraded gold dat0 chip. Flex cable not used but all soldering points have wires instead. All values are good compared with ones on YouTube. Training: initially pulsed yellow indefinitely. Flashed it with nx 0.7.2...
  2. T

    Hacking Hardware HW FLY V4 OLED Switch not turning on

    Currently at the shop getting the emmc reballed. The technician is a little confused because he says the USB c port is working properly and that there is no short. He’s going to reball it just in case. EDIT: dat chip was loose and not connected properly underneath. Will post again after reball
  3. T

    Hacking Hardware HW FLY V4 OLED Switch not turning on

    Going home and I’ll check for shorts. We noticed a capacitor acting weird. It’s definitely ground on one side (the top), and not ground on the bottom. Photos here: 1675364697 There’s a good chance I’m going to end up removing that flex ribbon and adding cables for my sanity. Trying to...
  4. T

    Hacking Hardware HW FLY V4 OLED Switch not turning on

    We attempted. We used a hot air solder, however, the video we watched recommended 360 degrees which is what we attempted at first. Since then we realized the temp should have been between 260-300. Super possible we fucked the emmc but we get good readings from the wire? We get OL reading...
  5. T

    Hacking Hardware HW FLY V4 OLED Switch not turning on

    Hey, yeah with the 3.3V disconnected it does not boot ofw. No fans spinning, no lights, nothing at all. For clarification, is the screen connector the ribbon cable just below the fan? I think see it is not fully connected in the photo as well. Will try properly connecting it and trying...
  6. T

    Hacking Hardware HW FLY V4 OLED Switch not turning on

    Yeah I know the thermal paste is hard to look at, makes me look like a complete dunce but thought accuracy was important at this stage. CLK point was damaged by me, i over scraped it and it got connected to ground. I then took it to a soldering shop and they connected a tiny wire from the...
  7. T

    Hacking Hardware HW FLY V4 OLED Switch not turning on

    Hi guys, I screwed up my HW FLY installation somewhere and now my switch is not turning on. I never managed to get any lights to turn on the mod chip and I also cannot get it to boot into stock now. Essentially pressing the power button does nothing. My battery is showing 4.14V, which I was...
  8. T

    Homebrew Question pkNX and LayerFS help

    Hey guys, Spent an ungodly amount of time trying to get pkNX to work for Pokemon Lets Go Eevee. I will create a condensed version of events of what I've done so far: Downloaded latest pkNX Dragged xci file onto hactool, and then selected the largest folder for pkNX (contains romfs /exfs) Got...
  9. T

    Gaming Randomization help - Lets go Eevee

    Hey guys, Just followed an in depth tutorial on how to randomize let's go Eevee for it to not work in one of the last steps. I was able to get my keys file, extract the XCI, and randomize my files. My fault comes at the injection stage. I previously had a Lets Go Eevee installed (not sure if...
General chit-chat
Help Users
    I @ idonthave: :)