Search results

  1. P

    Hardware Rapid Blinking Led Switch Dock

    Hello all, Got a faulty Switch that no matter what dock I put it in I get a flashing green LED. I can't find any shorts on the board. It turns on, charges and works fine Handheld. I have tried: New USB C port (checked and I have continuity on both edges of the connector) New PI3USB IC...
  2. P

    Hardware Black Screen issue after replacing BQ Chip

    Hi All, I bought a faulty switch that had a cracked screen and also didn't turn on. Opened it up to check for short and to transplant it into a housing that had a good LCD etc. All the caps around the BQ and some around the M9 chip had shorted, checking with a voltmeter it wasn't drawing...
  3. P

    Hardware 2DS appears to charge but doesn't

    Hi All, Have a Pokemon 2DS that just flashed red when you tried to use it, so I assumed it was the battery. The battery was replaced but it does the same it will turn on for 30 seconds flash red and then die. When I run it off the mains it works absolutely fine so I am assuming the charging...
  4. P

    Hardware Neither Joycon charges when attached to switch

    Hi All, I have fixed a switch that didn't boot. I have come to attach the joycons to test it and whilst they are detected and paired they don't charge, it is the same for both sides, when attaching them to a known working switch they do charge. So far all I have tried is; Disconnect the fan...
  5. P

    Hacking Performed my first ntrboot / boot9strap installation now what ?

    Hey all, Sorry if this isn't the correct place to post, I have checked a few of the sticky threads and can't see any answers and sorry if it sounds stupid. Just to say I have done it I have done my first 3DS ntrboot mod and installed Luma, I put a cia file on to play a game and it worked. What...
  6. P

    Hardware Dead Switch IC Replacement

    Hi All, Recently purchased a dead switch. No power, doesn't draw a current and battery dead. Battery is showing 2.73V I was getting a few shorts on the caps around both M92T36 and BQ24193. I wasnt getting any input from the USB C port, I fixed this by removing a couple bridges the previous...
General chit-chat
Help Users
    PandaPandel @ PandaPandel: some gamer gaming +1