ROM Hack (Request) Super Mario 3D All Stars Mraphic/FPS Mods

  • Thread starter Thread starter Duppex
  • Start date Start date
  • Views Views 58,247
  • Replies Replies 67
  • Likes Likes 1
I noticed GCFT produces an image where the dummy data is also replaced with randomized data when i went to build an IPS to patch the GCM.

I found the offsets directly from the GCM then patched just those addresses using the values @Kirby567fan posted earlier. I then created an IPS attached here for anyone else to use.

now all you need to do is use the zip posted earlier for the NRO patch then patch the GCM with this IPS file.

performance is still horrible, setting upscale to 0 actually crashes the game, 1 looks bad but runs way better then the default of 2 with this patch.

for me, i went back to 30FPS then set upscale to 3 to run handheld at 1920x1080, then i set upscale to 4 for docked mode so it will downscale back to smooth out the few remaining jaggies that exist on upscale 3.

Would you mind updating this? Thanks!
 
Here is the updated file.
Also the updated offsets are 0x3E40E0 and 0x3E21DC respectively.
Version 1.1.1 has a much better framerate than 1.1.0 so even without setting resolution to 480p it performs well but slowdows are still there in Delphino Plaza and some missions that revolve around a lot of goop.
I personally 100% the game using this patch along with dynamic shadows disabled and it was a really good experience.
If you are looking for a more consistent framerate you can either get rid of texture replacing and getting resolution to 480p or you could make the game run at 50hz which you can do with config file edits.
Hey, thank you for your mod, do you know what are the new offsets for the last update? Because i don't know what to change and i can't find the 1.1.0 anywhere
 
In case anyone is wonder; yes it still works on V 1.1.2
That said even with a max overclock on a v1 in handheld mode at 720p it's unplayable pretty much because of the abundance of slowdown. There's a good amount of spots that work fine but also lots that don't
 
Last edited by SK91,
In case anyone is wonder; yes it still works on V 1.1.2
That said even with a max overclock on a v1 in handheld mode at 720p it's unplayable pretty much because of the abundance of slowdown. There's a good amount of spots that work fine but also lots that don't
Which message specifically did you follow? Thanks.
 
I don't get it to work on 1.1.3 for some reason. (60fps on Sunshine)
can someone provide the patch?
with shadows enabled, please ;-)
thanks :)
 
Last edited by turntable97,

Site & Scene News

New Hot Discussed User Submitted