I have a V1 Switch where I replaced the charging port because it had bent pins. After replacing the port, I tested it with a tail insertion tester and it gave me good readings on each pin.
When I use the tester with the console powered on, it gives me OL on pins 7, 8 and 18.
The console can be charged and works docked, but the data connection doesn't work trough usb, when I put the console in RCM mode and connect it to the pc with a usb data cable, it does not get recognized by the pc in TegraRCMGUI.
Other things that I noticed is that console gives me an "unable to charge" message if I connect it to the pc with an usb cable, and the screen starts flashing/blinking randomly when I plug in the charger.
Any ideas what could be wrong and what should I try next? (I have already replaced the port twice)
When I use the tester with the console powered on, it gives me OL on pins 7, 8 and 18.
The console can be charged and works docked, but the data connection doesn't work trough usb, when I put the console in RCM mode and connect it to the pc with a usb data cable, it does not get recognized by the pc in TegraRCMGUI.
Other things that I noticed is that console gives me an "unable to charge" message if I connect it to the pc with an usb cable, and the screen starts flashing/blinking randomly when I plug in the charger.
Any ideas what could be wrong and what should I try next? (I have already replaced the port twice)
