PlayStation 5 - Fan Connector Repair

playsolve_s · 2026-06-08T14:38:01+0100

Hello everyone. I have a PS Repair with a fan connector broken. All great, not the worst situation that i have seen. I would like to ask for some help:
- After making jumper wire from the signal point, shall i connect the pin with the small capacitor here using a jumper wire? As i have seen, the trace is ripped of to the capacitor. Please advise.
Thanks to the community for this forum!

jkyoho · 2026-06-08T15:24:24+0100

yes, make your jumper connect to the cap at the end. If you are using small gauge wire, you could make few route in between to give the fan port pwm pin has larger contact area.

playsolve_s · 2026-06-08T17:17:27+0100

Thanks for the answer. I think i shall solder the wire to the bottom side of the capacitor - this one beeps when measured to ground. Am i right? Thanks in advance!

WhatsApp Image 2026-06-08 at 18.14.06.jpeg

Post automatically merged: 56 minutes ago

jkyoho said:
yes, make your jumper connect to the cap at the end. If you are using small gauge wire, you could make few route in between to give the fan port pwm pin has larger contact area.

Pls check the upper picture on which side shall i connect the jumper to the capacitor. Thanks in advance for your help bro!

PlayStation 5 - Fan Connector Repair

New Member

Well-Known Member

Attachments

New Member

Similar threads

Popular threads in this forum