Recent content by tiriannarnia

  1. T

    Hacking Fresh mod hack error

    Got some progress, no error shows when connecting board to usb, however when turning on switch i can see the nintendo logo followed by a static purple screen. Is this error software related? Sometimes it will even boot into normal mode, most times will stop at nintendo logo followed by purple...
  2. T

    Hacking Fresh mod hack error

    thanks for the the comment! that was my first ever solder connection and ended up messy, i have already redone it along with other bad connections the readings are now better too. I also ordered a enameled cable for the d0 adapter it might help according to some comments I found here. rn I try...
  3. T

    Hacking Fresh mod hack error

    I am back with another update: After using multimeter and fixing soldering connections my board now flashes blue and turns off without any errors. When connected into the switch with battery then error d0 not connected appears and boots into normal switch mode. When i remove the battery the d0...
  4. T

    Hacking Fresh mod hack error

    Thanks for your informative reply, the diode reading on d0 adapter is now 1700 a similar 1700-1800 range also reads on the D, A, C points on picofly. I take it 1700 is not the same as 0.7V? When connected the error changed into a short flash into a long flash: So now the new error is: CMD not...
  5. T

    Hacking OLED wonf start After mod, error b, y-y, y-y, y-y

    Hello, I am having the exact same issue using the same method as you. Can you explain what you did in this step? Resolderd point B directly to B on the modchip
  6. T

    Hacking Fresh mod hack error

    A small update: i tried another d0 adapter and tried switching into another flex cable since i got a extra set. The same error remains if that helps narrowing down the issue. In couple similar threads i checked with d0 error there were no real solutions and already tried recommended fixes like...
  7. T

    Hacking Fresh mod hack error

    Also i didnt ground sp2 as recomended in the guide i followed in YT, maybe this is related?
  8. T

    Hacking Fresh mod hack error

    Sorry but it looks like this error to me: =* D0 is not connected Also the point was to get a recommended solution from an experienced user since d0 is not connected is vague and i am not sure how to test my d0 point with the multimeter
  9. T

    Hacking Fresh mod hack error

    I have attached the issue for clarity
  10. T

    Hacking Fresh mod hack error

    Hello, I'm having some issues with a new Picofly installation. I have installed the latest firmware, but I'm receiving an error code through the LED flashes. The pattern is as follows: 1. A **blue** flash 2. A **long yellow** flash 3. A **short yellow** flash 4. (Then repeats) A **long...
See more