Recent content by Raugo

  1. R

    Installing large XCI

    Yes, you can.
  2. R

    Hacking Hardware Picofly - a HWFLY switch modchip

    You don't need to do it if you don't want but I think that you need a better printer to make a better fake cover.
  3. R

    Picofly AIO Thread

    If you have 2.5 you can't flash with pikotool.
  4. R

    Picofly AIO Thread

    I tried a lot of things and still have the problem wht the boot0/boot1 and slow mode of the emmc. I maked a emummc and can launch HOS from it. Is dangerous to leave it at this for the moment? I'm really tired and want to rest.
  5. R

    Picofly AIO Thread

    I replaced the wires with new ones shorted and now is worst, when I try to launch HOS with vol+ and vol- mpt sjpw amything at all except one time that show pink screen. It is possible that i damaged the emmc? Edit: I mounted the emmc in windows with hekate and can see the content and appear to...
  6. R

    Picofly AIO Thread

    Is strange, now I get this error when I try to launch HOS from hekate, I tried earlier and worked. I'm using 2.64 firmware in a fresh install. If I desolder the Dat0 the conosle launch hos without problem.
  7. R

    Picofly AIO Thread

    Ok, is all installed and get the no sd card screen but I have a problem, if I boot with vol- + vol+ to boot stock the console get stuck in a black screen after the nintendo logo.
  8. R

    Picofly AIO Thread

    Oh right, is a mariko normal (no oled no lite) @rehius that is not an option now because I have 3 points in the emmc now and to solder in the connector I would need to remove the emmc
  9. R

    Picofly AIO Thread

    Any other alternative point for th3 3.3v? I used the one from the emmc but it has come loose and I don't want to remove the emmc again so as not to lose the reset too and the one next to the memories is difficult because I have the chip right next to it.
  10. R

    Picofly AIO Thread

    I have a doubt about the 3.3v in the emmc board, in the picture appear to be shorted is that correct?
  11. R

    Hacking Hardware Picofly - a HWFLY switch modchip

    19,5 Ohm with the lowest resistance. Is a relieve because I had a lot of problem soldering the second mosfet. Thank you
  12. R

    Hacking Hardware Picofly - a HWFLY switch modchip

    Anyone with the cpu flex can tell me what value get the multimeter in continuity mode in the solder points? To check if I have solder mine well. I get 0001 and 0015 in the two points of the two mosfets
  13. R

    Hacking Hardware Picofly - a HWFLY switch modchip

    No, the upgrade feature was added in the 2.6 version.
  14. R

    Homebrew WIP [Official] switch-lan-play

    ldn.mitm convert the ad-hoc (connection between consoles without using a lan) to a lan connection. Without it you can't use lan-play in some games.
  15. R

    Unpatched Switch Not Going Into Recovery Mode

    You don't need to change SD, PC,, USB etc you don't need any of this to enter to rcm you need it to send the payload. Check if the vol+ works in HOS and if the joycon is recognied attached (to discard a problem with the rail) It doesn't matter, patched switches can enter to rcm too.
See more
General chit-chat
Help Users
  • No one is chatting at the moment.
    K3Nv2 @ K3Nv2: Nut on the hill