Recent content by generic_user_002

  1. G

    Hacking Help please - Acekard 2i ntrboot via NDS lite

    Halle-***ing-lujah! :yay3ds: It was definitely the contact! The contacts on the acekard were too low down in the plastic cartridge. i tried to shim under the PCB to raise them as suggested in the guide but that just raised the middle contacts, without raising the edges. In the end I (bear...
  2. G

    Hacking Help please - Acekard 2i ntrboot via NDS lite

    Right, so it should definitely show on the home menu?? Even if on v11.6? What does it show as, and acekard symbol or what? I think this might be the problem, I don't think the 3ds if reading the card. I was looking at this page https://wiki.gbatemp.net/wiki/Solving_Acekard_2i_Contact_Issues...
  3. G

    Hacking Help please - Acekard 2i ntrboot via NDS lite

    well i'm totally stumped then. I read on another thread that sometimes it's hard to make contact with the n3sxl and the acekard - I tried putting a paper shim behind it but no difference. If you look side on between the acekard and a regular game cart the contacts do look a bit higher up on...
  4. G

    Hacking NTrBootHax Problems with the magnet

    Did you ever get this resolved? I have the exact same problem: new3dsxl with 11.6 firmware and acekard 2i. No matter what I do I can't get it to boot ntrboot.
  5. G

    Hacking Help please - Acekard 2i ntrboot via NDS lite

    just realized that I never did step 5. of section II on the guide https://3ds.guide/flashing-ntrboot-(nds) I was never given this option - has the software changed?
  6. G

    Hacking Help please - Acekard 2i ntrboot via NDS lite

    actually i did try to flash it again. The acekard still keeps working in the NDS after flashing - or so I understand? Mine still works fine using Akaio on the NDS so I tried to reflash with ntrboot - same result as last time, seems to be successful, but still no luck when trying to boot it in...
  7. G

    Hacking Help please - Acekard 2i ntrboot via NDS lite

    Well not 100% sure - is there a way to verify? The flash process on the ds lite went fine I think.. selected inject ntrboothax, took a minute or so to get to 100% and then I hit ok and ejected it. When I put the flashcart into the 3ds should it show up on the home menu? Because I get nothing...
  8. G

    Hacking Help please - Acekard 2i ntrboot via NDS lite

    Hi, thanks for the help. I've tried many combinations! I just tried what you suggested again a few times but still no luck. Just boots as normal into sleep mode..
  9. G

    Hacking Help please - Acekard 2i ntrboot via NDS lite

    Hi, I'm trying to do the ntrboot hack on my n3dsxl running v11.6. I have an Acekard 2i and a DS Lite so I'm following the guide for "flashing-ntrboot-(nds)". The Acekard 2i is HW81 (confirmed via the Akaio help menu). I've followed all the instructions, flashed the flashcard, put the files...
  10. G

    Hacking struggling with hardmod - nearly there (?) but now stuck

    Hi, some help please if posssible... Am currently trying to hardmod my n3dsxl. I've done all the soldering and created the franken sd cable. Have an anker usb reader. I managed to dump my nand several times and all seemed to go successfully. I patched the nand with the b9shardmod installer...
  11. G

    Hacking 3DS NOOB PARADISE - Ask questions here

    Hello, have attempted a hardmod of a n3dsxl v11.5 and have run into an issue, can anyone help? I've been following the hardmod tutorial on this site and the 3ds.guide tutorial. So far I've done the following: Installed hardmod Successfully created 4 nand dumps using win32diskimager all of...
See more