Cant boot CFW or OFW

[Lujion]

Hello there, help me solve that puzzle with my switch

I have hacked mariko with sx core (ofw~12-13), and all was good, but after few years it start showing bad contact on v2,so i buy another cable that should be soldered on Aliexpress and change it.
Now my switch start good (flashing blue led near 1 min,than green LED) and boot in to hekate.But thats all.
If i try to reboot to OFW i have black screen (even no nintendo logo). If i try boot CFW from lauch menu - black screen (even no nintendo logo). Only if i load from payloads fusee.bin i see Atmosphere loading screen, but again it stuck,i waited few hours-no result. I tested emmc,sd card,all tests from hekate-all good. Tried to restore from my old backup (emuMMC) - no changes. Tried newest version of hecate and Atmo-no luck. What can it be?

 

[MoeXzl]

It's always helpful if you get a few pictures.

You may need to replace your resistors to 100 ohms for D0 and CMD.
It's also quite possible that your Nand partition is faulty or even empty.

 

[thesjaakspoiler]

Did you also try a clean install of Hekate?
Old files also messed things up for me once.
I think it was an issue with an old primary payload with a newer version of Hekate on the SD card.

 

[Lujion]

Did you also try a clean install of Hekate?
Old files also messed things up for me once.
I think it was an issue with an old primary payload with a newer version of Hekate on the SD card.

No,i fully deleted all old folders for atmo and hekate

Post automatically merged: Jan 13, 2024

It's always helpful if you get a few pictures.

You may need to replace your resistors to 100 ohms for D0 and CMD.
It's also quite possible that your Nand partition is faulty or even empty.

Uhhm sure,but I dont even know what should i photo?

Sorry, not quite sure where D0 and CMD can you show where I can see that?

And as for Nand - i should probably try to restore it,like on this guide,am i right?
(Using EMMcHaccGen and my dumped keys)


Also wondered is it will be safe to put back emmc and try to load that way,without chip, but with soldered to V1 and V2 cable?