- Joined
- Oct 29, 2013
- Messages
- 1,457
- Trophies
- 1
- Location
- Brazil, Sao Paulo
- Website
- www.gamemod.com.br
- XP
- 1,673
- Country
Hello,
I recently bought a Switch V1 with a failed to init eMMC error on Hekate.
The consoles instantaneously enters RCM mode once turned on and the eMMC benchmark only says it cannot be initialized.
I bought it since this could mean a lose eMMC module (never happened to me but could be the case) or, usually, a dead one, which a simply Swap and NAND recreation could make it work again.
But even after changing the eMMC to a known good one (two actually) the issue persists.
I checked the eMMC connector on the motherboard and, as far as I could see, there's no bent, missing or unsoldered pin:
The Switch was not opened previously and I could not see any scratches on the board or damage.
I was wondering if there is any CI, fuse or something like this that could go bad and cause this behavior.
Any tips are welcome!
Thanks!
I recently bought a Switch V1 with a failed to init eMMC error on Hekate.
The consoles instantaneously enters RCM mode once turned on and the eMMC benchmark only says it cannot be initialized.
I bought it since this could mean a lose eMMC module (never happened to me but could be the case) or, usually, a dead one, which a simply Swap and NAND recreation could make it work again.
But even after changing the eMMC to a known good one (two actually) the issue persists.
I checked the eMMC connector on the motherboard and, as far as I could see, there's no bent, missing or unsoldered pin:
The Switch was not opened previously and I could not see any scratches on the board or damage.
I was wondering if there is any CI, fuse or something like this that could go bad and cause this behavior.
Any tips are welcome!
Thanks!