hello, new here,
and probably asking a repeated question, but I did use search i promise.
looking to mod a v2 non-led switch, with one of those mail - in services.
what would you guys recommend,
Should I go with a pico fly or hwfly
with one of the chips available on Aliexpress something like: t i ny ur l . co m / 2p 9 ce8 hs , -> similar exist for hwfly
.don't want to go the custom microcontroller route with pico chip as the pre-assembled boards like the one above are much neater.
my requirements are pretty much average,
- ability to boot into ofw (may be as a default) as the switch is a shared one.
- and boot to cfw + atmosphere for myself.
- the chip firmware itslef should be flashable / upgradable without too much of ahassle like ripping out wires or soldering.
things like open switch, connect usb cable and upgrade is fine.
- OFW will be online, need online play (the full switch experience). CFW (emummc) would be the hacky bit with offline play only, or may be some online things.
- Any general good to know things that apply for modchip + cf, like never nver booting to sysnand + cfw from hekate launch menu, Always using reboot -> OFW to boot to OFW etc?
- can someone point me to a good guide for setting up the cfw (hekate + atmosphere + emummc and the stuff)? .
All tutorials I could find talk about v1 software methods, but nothing that I could find specifically for mod chip. I know that at some points the steps are same , but I am looking for instructions on what to do right after installing just the modchip, how to setup sd card for use with modchip, which button combination to use to load to hekate etc.
Thank you!