I tried to use my WiiU after some time in the closet, I forgot that I leave it configured to being used with the gamepad as the main screen, the problem is that it seems like the gamepad and the WiiU lost synchronization due to the long rest time, when I tried to use the game pad it shows an error: that it could not connect to the Wii U console, does anyone know how I can resolve this?
Need Help with my WiiU
- Thread starter xesdemitri
- Start date
- Views 3,415
- Replies 43
Doesn't it show anything on the TV screen? If so you can just use the sync button.
Assuming you don't have TV screen output:
Do you know if you used the wii u the last time with HDMI or with the AV Cable? Whatever it was you have to use the same one.
Assuming you still don't have a screen output:
If you turn on the Wii U with it's power button, the LD should turn blue. If you give it a minute or so to boot up and hen press the power button again, it should turn off again after a few seconds. Does that work or does the Wii U stay on?
Assuming you don't have TV screen output:
Do you know if you used the wii u the last time with HDMI or with the AV Cable? Whatever it was you have to use the same one.
Assuming you still don't have a screen output:
If you turn on the Wii U with it's power button, the LD should turn blue. If you give it a minute or so to boot up and hen press the power button again, it should turn off again after a few seconds. Does that work or does the Wii U stay on?
Last time I used was with the original hdmi cable but I stopped the video on tv due to the tv automatically changing to the hdmi when I tried to play and others were watching the TV so I left it set to repoduce in the game pad, now they aren't syncing and dont know how to change that setting on the console without the gamepad, or if is there a way to perform a factory reset without game pad, that could also help me.
To @Sypherone:
Already tried them, without luck.
Post automatically merged:
It shows this
Last edited by xesdemitri,
I was giving the big picture, it does not shows tv the screen, if turned on and then press it again it turns back off, it goes to Red light i am using the original hdmi that came with it
I will try again this weekend with both av and different hdmi, I need to borrow the av cable
Hello sorry for the long time for answer I had to move to another place, until now I was not able to use the WiiU for Troubleshooting, the thing is it turns on and off correctly, also the game pad starts the console, but when I tried to go to settings o to the game it shows the connectivity error, any Ideas?
well, there is another complexity to this the last time I played it I left the signal on the gamepad only, so I am able to see the quick menu screen but when I try to go to settings or to the game it shows the error, so I cannot tell for sure if the console shows the main menu, do you know any button combination to try to get the video back to the TVscreen?
Oh you only see the QS menu, that's not shown by the console it is entirely on the gamepad. So probably the console is crafting during boot.
But if it crashes you would need to press the power button long (4sec) to turn it off and not only short
But if it crashes you would need to press the power button long (4sec) to turn it off and not only short
already try it but it continues doing the same
Post automatically merged:
odd thing it loads a game disc without problems and shows the white light over the eject button, the disc drive made sounds like it is loading the game normally but still nothing changes neither on the screen nor the game pad
I tried the following:
- Powering off the console with the long press of the power button (4 seconds)
- I tried doing the same after removing the battery CR battery.
- Same procedure with a game disc inside the console (with and without Battery)
but it went to the same could not connect screen on the game pad, there is no signal on my TV with the HDMI Cable, neither the original one nor a generic one
no response with short press it goes down only with more than 3 seconds press
Sadly I think is dead
Post automatically merged:
Sadly I think is dead
UDPIH will probably not work in your car, so it's very likely you have to solder. Either defuse or NAND-AID and dumping the eMMC in hardware
Do you know when it was last used or what the installed firmware is?
Post automatically merged:
Do you know when it was last used or what the installed firmware is?
Similar threads
-
-
@
RedColoredStars:
You control a kitten. You fall out the window and have to make your way back home. Solve some light puzzles, do cat things like knock stuff over and steal things, trip people up when theyre walking, pounce on birds, complete goals/tasks etc. in the process of getting back to your home.+1 -
-
-
-
-
-
@
RedColoredStars:
@SylverReZ It's short but adorable imo. Im a HUGE cat lover.Can be completed in a couple of hours if just going for the main goals. But can be stretched out a good deal by exploring and doing everything there is to do and see.+2
-
-
@
SylverReZ:
@RedColoredStars, Reminds me of a similar game called "Neko Atsume", similar to Nintendogs but you look after cats. -
-
-
-
-
-
-
-
@
BigOnYa:
So a man goes to the doctor because his boner wont go down. As he is laying in the hospital bed, with his thing propped up in the air, a fly is flying around and landing on the tip and bothering him, so he calls in the nurse. The nurse comes in, swats at the fly but can't quite reach it, so she climbs his boner to get better aim. After a few tries of swatting and sliding back down, she says sorry I cant get it. He says keep going, a few more tries, and I can shoot the fly down.+2 -
-
-
-
-
-
-
#