Switching between Classic, Gateway, and Stock

Discussion in '3DS - Flashcards & Custom Firmwares' started by ProudPenguin, Jan 11, 2015.

  1. ProudPenguin
    OP

    ProudPenguin Newbie

    Newcomer
    7
    2
    Sep 5, 2012
    United States
    I couldn't find any info on it, so I'm sorry if it's already posted somewhere obvious. Currently, to switch between modes, I power off the 3DS, power it on, run the browser exploit, and select either Classic or Gateway mode. I have the DS card enabler CIA installed on my sysnand so I can use the blue gateway card as a DS mode flashcart. Is there any way to switch between modes without rebooting? If I run the exploit while in emunand, it just freezes the 3DS (which is expected I guess). Is there anyway to install the program in launcher.dat as a CIA?

    My current setup:
    9.2 sysnand and 9.4 emunand that are separated.
    DS Flashcart enabler CIA installed on sysnand
    Gateway 3.0.1

    Thanks in advance!
     
  2. Shady Guy Jose

    Shady Guy Jose GBAtemp Fan

    Member
    369
    129
    Sep 14, 2008
    Portugal
    With emuNAND active (either Classic and Gateway mode), go in and out of System Settings. You'll get kicked back to sysNAND. At this point, you're probably able to run the exploit again if you want to return to emuNAND. I know for a fact this works with 4.5 sysNAND and the DS profile exploit, I'm not entirely sure if it works with the browser one, but it should.
     
  3. SScorpio

    SScorpio Member

    Newcomer
    16
    2
    Jan 30, 2008
    United States
    Start and then exit settings. This will kick you back to the stock firmware. From there relaunch the browser exploit to enter Gateway or Classic mode.
     
  4. ProudPenguin
    OP

    ProudPenguin Newbie

    Newcomer
    7
    2
    Sep 5, 2012
    United States
    Thanks everyone for the quick replies!