Homebrew Luna3DS - Problem while booting

[Tenshi_Okami]

Got a tutorial to do this ?

Backup your SD card
Use EmuNAND9 and install RedNAND
Restore all of the SD files

And do the CTR Transfer to EmuNAND

 

[Barawer]

you booting into a black screen is normal:

1. For now, booting to a black screen or the message "An old unsupported NAND has been detected" on New 3DS is normal (New 3DS Luma3DS cannot boot a 2.1.0 NAND), just continue with the instructions

 

[runetoonxx2]

Stop using Luna3DS and start using Luma3DS

 

[Lokidari]

Backup your SD card
Use EmuNAND9 and install RedNAND
Restore all of the SD files

And do the CTR Transfer to EmuNAND

Got a SecureInfo_A error on step 2 while i want to use the CTR Transfer on EmuNand.

 

[gnmmarechal]

Can you try this: Check again if a9lh is installed correctly (Hourglass9, decrypt...etc), then use the recovery mode to update?

Recovery mode cannot be used on a New 3DS to go from 2.1.

 

[Lokidari]

Got a SecureInfo_A error on step 2 while i want to use the CTR Transfer on EmuNand.

Okay, post updated. I forced the transfer, actually, the CTRNAND do the transfer.

--------------------- MERGED ---------------------------

Backup your SD card
Use EmuNAND9 and install RedNAND
Restore all of the SD files

And do the CTR Transfer to EmuNAND

It's okay for the transfer. What should i do now? (still black screen)

 

[Tenshi_Okami]

Okay, post updated. I forced the transfer, actually, the CTRNAND do the transfer.

--------------------- MERGED ---------------------------



It's okay for the transfer. What should i do now? (still black screen)

Configure Luma3DS to boot EmuNAND

If it opens, backup the CTR NAND from EmuNAND and inject it to SysNAND