Starting out, I was working on the process to migrate data from a micro SD card to a larger one, following the steps in the switchway.net guide up to step 20.
After that, the Switch supposedly goes back to the OFW and I have to boot into RCM again. That's where my problem lies, it doesn't want to enter RCM mode.
I was using the Tinfoil Jig method. That method had always worked just fine for me on the first try, but this time, after several hours, Tegra keeps saying there's no RCM device detected. This is a bit confusing, and I honestly don't know where the problem is coming from.
I've already tried uninstalling and installing Tegra again, using different versions, different cables, and different PCs, and it's still the same.
Maybe I need to get a conventional jig? Or maybe something went wrong during the migration process? It's currently kind of bricked, but I plugged in the charger, and the temperature indicates it's charging. I really hope it's not hardware-related. My next idea was to clean the rail pins. Any suggestions? Maybe i'm missing something?
After that, the Switch supposedly goes back to the OFW and I have to boot into RCM again. That's where my problem lies, it doesn't want to enter RCM mode.
I was using the Tinfoil Jig method. That method had always worked just fine for me on the first try, but this time, after several hours, Tegra keeps saying there's no RCM device detected. This is a bit confusing, and I honestly don't know where the problem is coming from.
I've already tried uninstalling and installing Tegra again, using different versions, different cables, and different PCs, and it's still the same.
Maybe I need to get a conventional jig? Or maybe something went wrong during the migration process? It's currently kind of bricked, but I plugged in the charger, and the temperature indicates it's charging. I really hope it's not hardware-related. My next idea was to clean the rail pins. Any suggestions? Maybe i'm missing something?
