Hacking Homebrew without payload

[Storm18]

I have a switch but unfortunately it is 9.1.0, due to this I can't use the PegaScape exploit.
My console is unpatched since it's an older one, payloads and such work fine, but recently I have been getting annoyed that I have to use a device to send payloads in order to access certain things.
Is there anyway to some how get the PegaScape exploit or a way to get the console to boot into a CFW without the need of using a payload?

 

[nero99]

have someone install a trinket m0 chip in your switch. itll boot whateve payload you have it set to. its basically a mod chip but 10x less money.

 

[BaamAlex]

You already know what a vulnerability is. An exploit is a piece of code written to take advantage of a particular vulnerability. A payload is a piece of code to be executed through said exploit.

 

[Storm18]

have someone install a trinket m0 chip in your switch. itll boot whateve payload you have it set to. its basically a mod chip but 10x less money.

I'm looking at the trinket m0 chip, I could do it myself as it looks like only 5 wires need to be solder on the console.

 

[Lacius]

As mentioned above, a hardware modification is your only choice.

Alternatively, you could just leave the system in CFW and sleep mode when you're not using it.

 

[nero99]

I'm looking at the trinket m0 chip, I could do it myself as it looks like only 5 wires need to be solder on the console.

if you choose to do it, make sure you use flux, a 1mm solder tip, a iron that has adjustable heat, and lead based solder. avoid anything that say RoHS compliant, that stuff is garbage.

 

[Storm18]

if you choose to do it, make sure you use flux, a 1mm solder tip, a iron that has adjustable heat, and lead based solder. avoid anything that say RoHS compliant, that stuff is garbage.

I have a soldering station with a heat gun.
What I am just trying to figure out what type of electrical wire that I should get for it.
Would 28AWG 1.2mm or 30AWG 0.8mm be fine?