when I run Boot NTR Selector it loads for a few moments and then it says success but when I try to verify that it actually works by doing the x+y combo, boot ntr beckons not to work. who can help me? 
Boot NTR Selector mark "success" but does not work
- Thread starter takeyofr
- Start date
- Views 1,201
- Replies 5
an update was released to fix that problem. you need both the updated luma and an updated ntr boot selector. works fine after that.when I run Boot NTR Selector it loads for a few moments and then it says success but when I try to verify that it actually works by doing the x+y combo, boot ntr beckons not to work. who can help me?
Similar threads
- No one is chatting at the moment.
-
@
Psionic Roshambo:
I wonder if I could recommend that to some emulation devs that perhaps the sound could use some smoothing out to simulate those old TVs -
@
Psionic Roshambo:
I think a few of the early systems could benefit from that, at least up to the 8 bit generation, by the 16 bit generation I think TVs had gotten a lot better in almost every way
-
-
-
-
-
-
-
-
-
-
@
Xdqwerty:
it says it only works for the original R4, R4i Gold (r4ids.cn), R4iDSN (r4idsn.com) and Acekard R.P.G. -
-
-
-
-
-
@
Psionic Roshambo:
Just give it a try, but honestly if you have a 3DS you can play DS games without a card just off the internal SD card
-
-
-
-
-
-
-
