Hello guys,
I've been out from this for a while. I've updated my trinket and the setup screen shows the following:
Fusee_uf2 information. v6_110320
Following strap detected:
joycon
USB voltage:
chip-based auto rcm mode active
boot animation 2 selected
screensaver is active
However If I...
Good Morning guys, I was disconnected about this matter for a while. I am using method 3 and I would like to update my trinket with the latest version of Hekate. As far as I read in the previous post I have to take it from git. My question is: Witch one I should take?
Cheers
I have some issues running Doom. The only way I made it run is with ReiNX-SDFilesV731 deleting the fs_mitm.kip file. Is there a way to do the same with Hekate new release? Could someone explain the main duty of this kip module?
It looks like Chinese people are working on the same https://es.aliexpress.com/item/Dealonow-reemplazo-reparaci-n-clip-para-interruptor-RCM-NS-cortocircuito-herramientas/32908068356.html. I've checked the diagram they provided and I found out that there are two points for joy-con pin 10. My...
When you are in switch "Home page" of the firmware.
They found out that the operating system’s internal name is Horizon, that it is an evolution of the Nintendo 3DS system software, and implementing a microkernel architecture.
More info https://en.wikipedia.org/wiki/Nintendo_Switch_system_software
I would like to ask another thing. In case I want to compile the code you provided is there any extra library I have to install in Arduino IDE? I've read in other post that if we would like to compile the source code we need to install extra libraries.
Do you have any step by step guide?
Cheers
I've changed the pin 2 to the correct switch point. I do not have any dock here as I'm not at home But I guess I could try with the PC because when I hat the wrong point it did not charge the switch when It was turned off. I will keep you posted. Again thanks to every one who helped me out ;)...
Good morning guys!
I’m confused of what happen with my pink wire. As far as I have checked the pink wire should go from pin10 joy con to pin 3 of trinket right?
As far as I checked there is no bridge either usb or trinket usb pads.
Could you please give me some lights here as I don’t know how...
Hola! (Barcelonés viviendo en Madrid).
The photo I have is one I took after install. No good quality and I added glue to the trinket usb because taking it out the component I destroyed a little bit the pads. Anyway photo below.
https://ibb.co/mhx6i9
I do not have any spare dock to give a try...
Today I found out that when the switch is in dock and Switched off the dock station start blinking but nothing happen no charge no image and I have to turned off the dock station to make it work. I’m using method 3 without volume + wire. Is that normal?
I've tried the las version provided by M-O-B and it works perfectly find. However I will stay for now in Hekate. Regarding the reset button to reprogram the trinket Are you having a hole on the case in order to access it? Or you just open the switch all the time you want to update it?