did you just cut and sand the rail to be flat then glue it to the joy con strap? i.ve just been using a rail with a piece of electrical tape covering the wire, i dont have any extra joycon straps though.
thanks for the idea, i am not super familiar with hex editing stuff i did just look at them both in a hex editor and they ended on the same offset. I feel the risk of my making a brick is a little to high if i start copying data over where they differ.
I think i am going to go with starting...
This is kind of long because i am trying to explain everything i have done. I have backed up and restored my nand a few times in the past to go from playing with homebrew to clean switch for updates, with no problems. This time however i get the "size of the sd card backup does not match emmc...
i used to go out to the recycling center every couple weeks and look at the crts and other electronics people would drop off. Usually screens were broken or severely scratched from being tossed around. Did find a good one here and there, but never anything like a 1080i widescreen crt.
I have a few of those boat anchors in my basement I tried giving away but no one wanted them, So anyone close to Columbus, Ohio area that wants them, (26", 2x 19") please come get, for free.