Recent content by tommy97

  1. T

    PS5 Slim no power

    Hi guys, I’ve got a PS5 Slim (EDM-044) in today with a no-power issue. All fuses are good, and I haven’t found any shorts. The following voltages are present: 12V 3.3V 5V 1.2V 1.8V I was initially able to read the UART. However, after attempting to clear the error codes, I’m no longer able to...
  2. T

    PS5 Slim EDm-044 RAM Issue?

    Hi guys, Did any1 had problems with this error code? It comes from QA inspector just in less than a minute on RAM and full load test, uart does not have any errors. Console works however it shows colour artefacts while playing ps5 games.
  3. T

    PS5 Error on the games [Error:CE-108255-1]

    What if I use same model in same order from donor board?
  4. T

    PS5 Error on the games [Error:CE-108255-1]

    Hi everyone, I’ve got a PS5 with what I presume is an SSD-related fault.The console works perfectly with PS4 games; however, PS5 games either fail to load, display an error, or cause the console to power off. I’ve already replaced the SSD controller, but unfortunately that didn’t make any...
  5. T

    PS5 SSD Problem? [ERROR CE-108255-1

    Hi everyone, I’ve got a PS5 with what I presume is an SSD-related fault. The console works perfectly with PS4 games; however, PS5 games either fail to load, display an error, or cause the console to power off. I’ve already replaced the SSD controller, but unfortunately that didn’t make any...
  6. T

    PS5 1 Sec BLOD (RAM)

    Hi guys, I'm having an issue with a PS5 EDM-030. It has no power and shows a 1–2 second BLOD. UART initially reported an error on RAM Bank 4, so I replaced the RAM chip. However, the console is now throwing the error shown below. I replaced the original SK hynix RAM chip with a different SK...
  7. T

    PS5 Dualsense stick drift

    Hi, I’ve been dealing with some stick drift issues on PS5 DualSense controllers. I’ve replaced the analogs on 4 different controllers using parts from 3 different suppliers (Mobile Sentrix and some from eBay), but I’m still getting slight drift, around 0.01 to 0.05 — only noticeable when zoomed...
See more