Purchased my Switch used with 6.0.1 so I never had any fear of accidentally booting to stock FW since the fuses were already burnt. Decided to install my Trinket M0 internally and use the RCM strap before updating to 9.0.1
As my luck would have it, while testing my Trinket after updating to...
Hello!
Long story short I installed my Trinket M0 internally, it boots fine, and I installed autoRCM since I ran out of wire. Not sure if this is normal behavior or not but I cannot load a payload with the charger connected. It has to be unplugged for the Trinket to load my payload
Instantly...
Hello!
Long story short I installed my Trinket M0 internally, it boots fine, and I installed autoRCM since I ran out of wire. Not sure if this is normal behavior or not but I cannot load a payload with the charger connected. It has to be unplugged for the Trinket to load my payload
Instantly...
Had my Switch for roughly a year now, have been using SX OS, and sending payloads using my Moto Z2 Force since the day I bought it. For roughly 6 months I was using one of the most popular OTG adapters on Amazon and an Anker type C cable to send my payloads. After a trip to MicroCenter I built a...
So would "TRINKET_REBUG_SIMPLE_UF2_V097.UF2" be the payload pusher? I've read over your tutorial multiple times and I feel like something is just flying over my head. In my head these are the steps:
1. Flash SWITCHBOOT file SWITCHBOOT_TRINKET_JOYCON_VOLUME.uf2 for joycon + volume. This is the...
Thanks! After reading your tutorial I was under the impression I would need to flash the SWITCHBOOT file and then the Simple UF2 file. Do I only need to flash the SWITCHBOOT file if I'm installing internally?
Needing a bit of guidance here.
I have an Adafruit Trinket M0. I've already flashed SWITCHBOOT_TRINKET_JOYCON_VOLUME.uf2 to it and that worked, but I'm a bit confused on which Simple UF2 to pick from here: https://github.com/mattytrog/Simple-UF2/tree/master/SIMPLE-UF2_v097/UF2
I know it's not...
Friendly reminder to backup your NAND in more than one place. My timing was damn near perfect; I had both my NAND backups on an external hard drive. It's a pretty old and today I got the dreaded click-of-death. Just a few days ago I compressed my NAND backups so they would fit on a spare 64gb...
This makes sense, I was thinking that might have something to do with it. I may look into using hactool in the future but that'll have to be when I've got a free weekend or something. Even tho both my backups are taking up roughly 60gb, I've got backups and that's what's important.
@gg11...
Are you asking if I tried WinRAR or what WInRAR is?
As I mentioned, yes I've tried WinRAR. If you're asking what WinRAR is in some good compression software that's old enough to drink: https://www.rarlab.com/
So I've tried multiple compression types with 7zip and WinRAR and I'm only saving roughly 2gb on both my SX OS and Hekate NAND backups.
I purchased the Switch used (couldn't find a new exploitable one at any local stores) and it came with FW 6.0.1 installed. The second I got the Switch out of...