Recent content by smhrambo

  1. S

    Hacking Feedback I fucked up my brother's switch

    If you really want to try it yourself and are not familiar with SMD soldering. Remove the board from the housing. Heat the remaining component with a soldering iron and add solder to remove it. Use a desoldering wick to clean the pads(flat tip + flux). Use solder paste on the pads and place...
  2. S

    Hacking Feedback I fucked up my brother's switch

    Is this normal?
  3. S

    Need help flashing old backup and going online?

    But in the thread it says “Best Way to Avoid Bans”: 3. restore the clean NAND backup as well as boot0/boot1 before going online. Or what do you mean by old backup? The goal is to buy a Nintendo 64 controller, for which I need nintendo switch online.
  4. S

    Need help flashing old backup and going online?

    Sorry for my late response. Thank you very much. My emunand is still on the SD card, and I want to use it. I don't know what firmware version my switch was on when I was online last time. Are there other risk-free ways of updating?
  5. S

    Need help flashing old backup and going online?

    Hi, i want to restore my sysnand to go online. I have a switch v1 with trinket m0 chip and i found old 2 backups. Backup 1 files from 2018 BOOT0 BOOT1 rawnand.bin.[00-04,07] partitions\BCPKG2-1-Normal-Main partitions\BCPKG2-2-Normal-Sub partitions\BCPKG2-3-SafeMode-Main...
  6. S

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    I will test it again tomorrow.
  7. S

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Hi, I have a little problem with my trinket m0 modchip. It is not displayed in Windows Explorer. I installed the ModChip in early 2019 and it works as it should. But I cannot update the payload. The modchip is connected with 4 wires and use autorcm. My approach: I load the Samd21Update payload...
  8. S

    Hacking My switch died while it was in cfw (atmosphere)

    If it has a modchip, disconnet the powersupply and try again.
  9. S

    Homebrew Question EdiZon cheats are always active

    Cool that worked, thanks
  10. S

    Homebrew Question EdiZon cheats are always active

    Hi, I have the problem, that every time i start a game edizon activates all cheat codes. What I tried so far: Start the game. Go back to edizon. Deactivate all cheats. Go back to the game. Play a little bit. Save the game. Kill the game. Restart the game, but all cheats are active again.
  11. S

    Hacking WIP [Trinket] [Rebug] [Others] SWITCHBOOT_UF2 / FUSEE_UF2 modchip software

    Hi, i'm using a Trinket M0 with the old Method1 4-wire setup and AutoRCM. After all the time i want to update the modchip, which "Simple UF2" file should I use?
See more