Recent content by Papaille

  1. P

    PS5 slim (EDM-040) BLOD (10 seconds to infinite)

    That’s m’y next move, replacing the ssd controller. I will post here the issue
  2. P

    PS5 slim (EDM-040) BLOD (10 seconds to infinite)

    Thanks for your reply. Do you think it’s normal that not any nand get warm during the infinite blod? Regarding to that, do you think at something else (other than the ssd controller) in order to resolve the problem ? Thanks again
  3. P

    PS5 slim (EDM-040) BLOD (10 seconds to infinite)

    To complete, i use a thermal camera to observe what component is warming in blod state After 10 seconds, in ssd aera, only the controller is hot
  4. P

    PS5 slim (EDM-040) BLOD (10 seconds to infinite)

    Hello, thanks for your reply There is nothing about liquid metal spilling. I will double check again, but i’m pretty sure everything is fine in this way. In addition, ssd controller is on the opposite side of the apu on edm-040 board. Could it be the ssd controller itself? Resistance on 0.8v...
  5. P

    PS5 slim (EDM-040) BLOD (10 seconds to infinite)

    Hello Everyone I brought a defective PS5 slim (rev EDM-040) First failure was the psu (OV output). After replacing IC32, it work again Second failure (and that's why i'm here) is the motherboard stay in a BLOD state. What i've already done : - Idle Consumption : 0.07A up to 0.221A for 3...
  6. P

    PS5 digital / No Power / No Beep / Good power supply

    Hi everyone, Bought a non functionnal PS5. Apparently only a bad PSU... No beep, nothing. After some tests i found this : - PSU is fine (12 volts stable) - 12 volts line is shorted - DA9065 was fried, F7003 also => Replaced both of them, short is gone on 12 volts line, no dead short anywhere...
See more