If checksums are used for identification, recognition of nsp files often fail because of the nature of nsp files. It should work well for xci files. Maybe that's the problem.
It depends if you are fine with intact game data or care about the padding data, too.
To check the padding data, you need to do a full disc dump with a special drive.
If you just want to check game data, you could copy the game on a hacked x360 to HDD. If there are no errors, your disc is fine...
B is Vol+
I have the same modchip and some additial questions:
From Trial&Error I now know that "A" Pad is Joycon strap and "B" pad is Vol+.
But there does not seem to be any place left to use for the USB disconnect wire.
Also, I noticed when I do the 4 Wire install without Vol+ and when I...
My resistors from ali arrived today. Added 100 Ohms to dat0/cmd. Slow EMMC issue is gone and booting to CFW/OFW works just fine now! Thanks a lot for the tip, even though it's mentioned in the guide, I would have probably not figured it out.
It's booting package3.
And as @deeps pointed out, black screening when trying to boot OFW does not point to a software problem. If the OFW problem is connected with the "unknown pkg1 version" error, I don't know.
Hekate boots up fine. I literally did the plain atmos/hekate thing.
For reference what I did from empty SD card:
* Extract atmosphere-1.5.4-master-3cb54e2b4+hbl-2.4.3+hbmenu-3.5.1.zip to root of SD
* Extract bootloader folder of hekate_ctcaer_6.0.5_Nyx_1.5.4_v2.zip to root of SD card
* Copy...
Thanks for the tip. I installed a hwfly style board with flex cables, so it's kind of hard for me to do that.
I unplugged the chip, and booting was fine. I was on 16.0.1 (much newer than I thought) and updated to latest 16.0.3 but I still have the same issues.
Would it be possible that this...
Hi,
I successfully installed picofly on a lite, getting the "no sd card" screen.
I prepared the SD card with sdsetup.com.
When I try to launch atmosphere, I get the error "unknown pkg1 version".
I tried to google it but couldn't make sense of it. Seems like the general solution is to update to...