Recent content by MarkSummers

  1. M

    Dbrand no longer selling PS5 faceplates after Sony threatens legal action

    Same. I would get them for the disc edition if they came out with a special left side plate that mimicked the disc drive on the right. That way the whole thing could be symmetrical when standing even if one side was just a dummy bulge.
  2. M

    Nintendo Switch Online Expansion Pack pricing information revealed

    They probably priced it based on what their market research showed for each region. The expansion pass will sell like crazy in every region. Digital goods in the U.S. will sell really well this Christmas anyway with the physical shipping container crisis.
  3. M

    Switch OLED teardown V1/V2

    If you need a different voltage check around the coils, unless its coming off the main power chipset that used to get fried in the third party dock fiasco event.
  4. M

    Nintendo Switch Online Expansion Pack pricing information revealed

    I'm sure Nintendo set this price because people will be willing to pay it. I guaran-freaking-tee you GBATemp is not Nintendo's target market for this service, right up there with wildebeest and the planet Neptune.
  5. M

    Switch OLED teardown V1/V2

    I thought this initially as well, but given how point D on the board is very obscure, they were digging around quite a bit. I'm not holding my breath the emmc's Dat0 (Point C) comes out anywhere except a pin under the APU. Using one of these may require lifting the eMMC. I've never done...
  6. M

    Switch OLED teardown V1/V2

    If C is the only possible attachment point you can probably get the wire there without lifting the nand chip by heating the nand up and slipping the wire into the flattened solder ball... actually that's not going to work because the grid is much smaller than the size of the chip, it'll have to...
  7. M

    Video shows OLED Nintendo Switch using HWFLY SX clone modchip, can boot Hekate

    Nintendo could have gotten more seclusive with what information they put in public firmware since SciresM started analyzing the firmware revisions. But really there is no point in a new switch revision. To piggyback DLSS onto the chip would require so much engineering it would be more cost...
  8. M

    Switch OLED teardown V1/V2

    Eh? Anyone thats a novice in boardwork can figure out what the new NAND points are if they have a Switch Lite and a OLED. You just hot air the NAND chips off the boards of both consoles. Run a continuity test between each of the SX Lite's solder points on the Switch Lite and find which ballpoint...
See more