Recent content by Man5on85

  1. M

    PS5 EDM-030 reboot safe mode 808E0006

    Hi everyone, I have a PS5 EDM-030 that boots into safe mode. When I plug in the controller and press the PS button, it restarts. It does this endlessly. This is how the error codes are read. Any advice on what to check? Could it be a problem with some RAM module, SSD controller or Memory...
  2. M

    PS5 Slim EDM-044 component identification help

    thanks so much
  3. M

    PS5 Slim EDM-044 component identification help

    Hi everyone, I have a PS5 Slim motherboard with an EDM-044. I needed to identify this component. The code is only partially legible: PG003 Attached is the photo of the component and its position. thanks
  4. M

    PS5 EDM-033 blue led 1 seconds power off

    Hi, I have a ps5 EDM-033 that lights up blue for 1 seconds and then turns off the start sequence is correct, it reaches 320ma and then drops to 10ma checking the card I didn't find any shorts Reading the codes via huart gives me the following errors: 01 31/05/2025 10:48:09 80801F12 Low Known...
  5. M

    PS5 EDM-033 UART 80810001 Beep 1 second Ligth

    checking on another board same model working, these voltages that I marked in standby are missing
  6. M

    PS5 EDM-033 UART 80810001 Beep 1 second Ligth

    checking carefully I noticed that some voltages standby are missing in the hdmi circuit, I have already tried to change the panasonic chip those circled are not present.
  7. M

    Ps5 ce-10855-1 hardware fix

    Ciao sei poi riuscito a risolvere il problema ?sono nella stessa situazione.
  8. M

    PS5 EDM-033 UART 80810001 Beep 1 second Ligth

    ok, I hadn't taken the SSD controller into consideration because, looking at it with the thermal camera, it heats up like when it initializes. so, do you recommend that I try to reflow the SSD controller or change it?
  9. M

    PS5 EDM-033 UART 80810001 Beep 1 second Ligth

    Thanks for your interest, not only this error code. I attach a photo sorry for the quality of the photo, I took it like this as a reminder
  10. M

    PS5 EDM-033 UART 80810001 Beep 1 second Ligth

    Hi everyone, I have a ps5 EDM-033 that beeps, blue light for 1 second and turns off. reading the error codes via uart gives the following code: 80810001 General power failure (periphery, GDDR6, APU, data line shorted) checking the card I didn't find any shorts, Boot sequence is quite right...
  11. M

    PS5 EDM-033 20 second blue led, power off

    Hi everyone, I have a strange problem with a PS5 EDM-033. lights up with blue LED flashing for 20 seconds and turns off. reading the errors via UART gives me the following codes: Operation: Run Read Error Codes [Slot #] [Date Time] [Error Code] [Priority] [Error Message] 00...
  12. M

    Hardware switch oled not turn on. no current absorption

    yes, as I imagined, I was waiting for someone's confirmation. some are capacitors that go directly under the tegra chip. Thank you for your reply
  13. M

    Hardware switch oled not turn on. no current absorption

    Hi, hope someone can help me. I have an OLED switch that doesn't turn on. connected with USB tester it does not give any absorption. the connector seems good because there are 5v on the board. on the capacitors circled in the photo I find a low resistance of 20ohm removing the M92T36 and p13usb...
  14. M

    PS5 LAN not working after storm

    ok thanks, I'll try to take some measurements around the southbridge
  15. M

    PS5 LAN not working after storm

    Hi everyone. I have a PS5 that doesn’t recognize the LAN cable after a storm. the console initially did not turn on. changed panasonic hdmi chip and now it works fine. I also wanted to restore the LAN port. I have already changed the resistors, the gst5009s module. now I have a short in the...
See more